Filter
Top Products
Pelco Manual C1927M (5/99) 29
HELP MENU
The Help menu is accessed from any other menu.
1. Use the up and down arrow buttons in any menu to highlight HELP.
2. Press the +/- button. The Help menu appears.
Figure 18. Help Menu
GROUP QUAD (2x2)
104
204
304
404
NINE (3x3)
04
04
DISP/REC
BUTTON SETTING
VCR SPEED & ALARM
QUICK SETUP
MONITOR SETUP
HELP
+/– - SINGLE PRESS MODIFY
DOUBLE PRESS CHANGE
EDIT DIRECTION
HOLD BUTTONS TO ENTER/EXIT
THEIR ASSOCIATED MENU
USE ARROWS TO NAVIGATE
Figure 17. Camera Sequence Menu
MULTIPLE CAMERA DISPLAY SETUP
The multiple camera display formats may be configured using the front panel controls. The
LEDs above the camera buttons will illuminate to indicate which cameras are being displayed.
PROGRAMMING THE PICTURE-IN-PICTURE DISPLAY
( BUTTON)
The on-screen location and size of the picture-in-picture (PIP) display are programmable.
PIP is not available in VCR or RECORD modes.
To program the PIP display:
1. Press the button.
2. Press the button (for approximately three seconds) until the message PROGRAM
PIP SIZE appears.
3. Use the arrow buttons to increase or decrease the PIP display size.
4. Press the +/- button. The message PROGRAM PIP POSITION appears.
5. Use the arrow buttons to move the PIP display location.
6. Press the +/- button to exit the PIP programming menu.