Filter
Top Products
Pelco Manual C681M-D (2/02) 43
3. Turn the JOG dial to move the cursor to CH.TITLE, and then turn the SHUTTLE ring
to the right. The option starts flashing.
NOTE:
If the PRE A-REC field in the A-Rec/M-Det Setting menu has been set to
SHORT, MEDIUM, or LONG, the option does not flash because it cannot be
changed.
4. Turn the JOG dial to select the option, and the turn the SHUTTLE ring to the right to
finish setting.
Turning the JOG dial switches the title options as follows:
NONE, TITLE, CH. NO
NONE: Camera numbers and titles are not displayed.
TITLE: Camera numbers and titles are displayed.
CH. NO: Only camera numbers are displayed.
5. Do one of the following:
•Turn the JOG dial to go to another item in this menu.
•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.
ALARM DISPLAY
When the unit receives an alarm input signal, the monitor displays images from the camera
with the alarm. If, during alarm recording, the recorder receives another alarm input signal,
the monitor displays images from the latest alarm recording camera channel. (The display
is single-camera mode.) The monitor returns to its original display mode after alarm record-
ing is completed.
Skip steps 1 and 2 if they have already been done.
1. Press the SET UP button to display the Menu Setting menu.
2. Turn the JOG dial to move the cursor to MPX DISPLAY, and then turn the SHUTTLE
ring to the right. The MPX Display menu appears.
3. Turn the JOG dial to move the cursor to ALARM DISPLAY, and then turn the
SHUTTLE ring to the right. The option starts flashing.
NOTE:
If the PRE A-REC field in the A-Rec/M-Det Setting menu has been set to
SHORT, MEDIUM, or LONG, the option does not flash because it cannot be
changed.
4. Turn the JOG dial to select ON or OFF, and then turn the SHUTTLE ring to the right.
The option stops flashing.
5. Do one of the following:
•Turn the JOG dial to go to another item in this menu.
•Turn the SHUTTLE ring to the left to return to the Menu Setting menu to go to an-
other menu.
• Press the SET UP button to exit the programming mode.