Filter
Top Products
Pelco Manual C681M-D (2/02) 71
INFORMATION
ELAPSED TIME DISPLAY
1. Press the INFO button. The Information menu appears. The elapsed time appears in
the lower part of the screen.
2. To exit the menu, press the INFO button again.
The elapsed time of main hard disk drive, archive device, and copy device are shown
on the screen. The elapsed time for the archive or copy devices will not be displayed
unless they are connected to the recorder.
The elapsed time of main hard disk drive is counted when the recorder’s power is
turned on.
The elapsed time of the peripheral device (ID4) is counted:
• When the ARCHIVE button illuminates or flashes
• When the PLAY or REV PLAY button illuminates or flashes when the archive de-
vice is selected as a playback device using the PLAY DEVICE button
• While the ARCHIVE indicator illuminates or flashes when restoring the data from
main hard disk drive to the archive device
The elapsed time of the peripheral device (ID5) is counted:
• When the PLAY or REV PLAY button illuminates or flashes when the copy device
is selected as a playback device using the PLAY DEVICE button
• When the COPY indicator illuminates or flashes when copying the data from
main HDD to the copy device
• When the COPY indicator illuminates or flashes when restoring the data from
main HDD to the copy device
The elapsed time of the archive device or copy device will not be reset even though
those devices are disconnected.
The elapsed time of archive device starts when the ARCHIVE button is pressed (when
pressed, the ARCHIVE button illuminates), even when there is no data on the main
hard disk drive, such as when the recorder is in the alarm standby mode.
The elapsed time may not be consistent with the normal time for wearing of parts.
The elapsed time is shown up to a maximum of 999999 hours.
POWER FAILURE LIST
If your system has had power failures, you can view the Power Failure list to see when they
occurred. Up to 50 power failure starting times are shown on the list. If there are more than
50 times, the last 50 starting times are shown.
1. Press the SET UP button to display the Menu Setting menu.
2. Turn the JOG dial to move the cursor to SERVICE, and then turn the SHUTTLE ring to
the right. The Service menu appears.
3. Turn the JOG dial to move the cursor next to POWER FAILURE, and then turn the
SHUTTLE ring to the right. The Power Failure list appears on the screen. The number
of times, the date, and the time when the power failure occurred are given on the list.
To reset the power failure start time, press the WARNING RESET button when the
Power Failure list is shown on the screen.
4. Press the SET UP button to exit the menu.