Filter
Top Products
C626M-C (5/06) 221
Adding a DX8000 Server with an Unknown IP Address to a Group
To add a remote DVR site to a group in the Connection List when you do not know the IP address of the site:
NOTE: To be successful, the following stipulations must be satisfied:
• Each DVR must be attached to the same subnet.
• The first three octets of the IP address of the subnet must be known.
• The range of addresses used in the last octet of the subnet must be known.
1. Click . The Connection List dialog box opens.
Figure 209. Connection List Dialog Box
2. Do the following:
a. Select a group.
b. Click DX8000 Scan. The DX8000 Scan dialog box opens.
Figure 210. DX8000 Scan Dialog Box
3. If your server is on Network Address Translation (NAT), click the Server on NAT check box.