Pelco es30-isap TV Mount User Manual


 
14 C312M-A (12/02)
QUICK START GUIDE – SYSTEM SETUP
PROGRAMMING GUIDE – ES30-ISAP PAN AND AND TILT SYSTEM
1. Access main menu (preset 95).
2. Make main menu selections.
Joystick: Move up or down to position cursor or to toggle between selections.
Iris Open: Enter.
Iris Close: Cancel.
MAIN MENU
<Camera>*
<Line Sync>
<Power Up Mode>
<Limit Stop>
<Other>
EXIT
Power Up Menu
Power Up
Exit
Line Sync Menu
Line sync
Line sync phase
Exit
Camera Menu
Polarity
Auto Cal
Man Cal
Reset Camera
<GAIN/AGC>
Next
Exit
Limit Stop Menu
Limit Stops
Set Man Limits
Clear Man Limits
Set Scan Limits
Clear Scan Limits
Exit
Other Menu
Proportional pan
Park time minutes
Scan speed deg/s
Pattern length
Spd Profile
<Zone Blank>
Exit
Zone Blank Menu
Video Blank Zone 1
2
3
4
5
6
7
8
Exit
Next Menu
ROI
Color Bar
Cam Ver
Prev
Exit
Gain/AGC Menu
AGC mode
Gain
Offset
Exit
PRESETS
The following presets are reserved for
special functions:
Preset Function
1Park
33 Flip command
34 Pan zero command
89 Toggle Polarity
90-91 Manual Limit stops
92-93 Auto Limit stops
95 Access Main Menu
96 Stop a scan
97 Random Scanning
98 Frame Scanning
99 Start Auto Scanning
NOTE: For AMERICAN DYNAMICS
controllers with only 32 presets, set
switch SW1-5 on the PCB in the ON
position. When SW1-5 is ON,
preset 99 becomes 32
98 becomes 31
97 becomes 30
96 becomes 29
95 becomes 28
93 becomes 26
92 becomes 25
91 becomes 24
90 becomes 23
If the limit stops are turned off (refer to
the
Limit Stops
section), presets 23-26
can be used as regular presets.
NOTE: In the operation and pro-
gramming instructions, sometimes
a number in parentheses follows a
preset. This second number is for
32-preset mode.
*For information on camera
operation, refer to the
manual supplied with the
POD 100 thermal imager or
contact Industrial Security
Alliance Partners, Inc. at
(619) 232-7041.