Filter
Top Products
6 C312M-A (12/02)
PAN AND TILT
1. Remove the transformer module from the base of the system by loosening the four Phillips screws and lifting the module.
01475
BASE
MOUNTING
SCREWS
MOUNT
LOOSEN
PHILLIPS
SCREWS
TRANSFORMER
MODULE
BASE
2. Attach the base of the system to an Esprit mount (EWM or EPP) with the three flathead 10-32 x 1/2-inch screws and washers
(supplied).
Figure 3. Transformer Removal
Figure 4. Base Installation on Mount
NOTE: The illustration shows the ES30-ISAP Pan and Tilt System mounted to an EWM wall mount.