Pelco es30-isap TV Mount User Manual


 
C312M-A (12/02) 7
3. Route the wires and cables from the transformer module through the center of the Esprit mount. Reinstall the transformer module
into the base. The transformer module can be positioned in the mount base in only one orientation.
120/230 VOLTAGE
SELECTOR SWITCH
4. ES30-ISAP-5 Model Only – Set the 120/230 voltage selector switch on the transformer to the appropriate voltage.
5. Connect wires and cables.
a. Connect to power.
Figure 5. Transformer Reinstallation
120/230 VAC
Black wire Input (AC Line)
White wire AC Neutral
Green wire Ground
24 VAC
White wire Input (AC Line)
White wire AC Neutral
Green wire Ground
b. Connect the video coaxial cable to the BNC connector.
c. Connect the wiring for a two-wire or four-wire control system. This step does not apply to Coaxitron
®
control systems.
Green wire RX-
Red wire RX+
Black wire TX-
White wire TX+
6. Install mount; refer to the installation manual supplied with the mount for instructions.
7. Turn on the power. If the red LED lights, turn off the power and proceed to the next step.