Filter
Top Products
18 C312M-A (12/02)
Clear Manual Stops
To clear the manual limit stops:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Limit Stop.
3. Press the Iris Open button to enter the Limit Stop menu.
4. Move the cursor to Clear Man Limits, and press the Iris Open button. The cursor will flash to an asterisk (*) briefly to indicate the
limits have been disabled.
SCAN LIMIT STOPS
When scan limit stops are set, the pan and tilt reverses direction during random, frame, or auto scanning when a limit stop is reached.
The manual scan limit stops can be set in one of two ways:
At the controller by programming presets 92 and 93
or
At the controller by programming the Limit Stop menu:
Presets
Refer to the documentation for your control system for programming presets, then do the following:
1. Make sure limit stops are turned ON, and then exit the menu.
2. Push the joystick left until you reach the limit you want the camera to go to on the left.
3. Program preset 92 (25).
4. Push the joystick right to the limit you want the camera to go to on the right.
5. Program preset 93 (26).
Setting presets 92 (25) and 93 (26) to the same point disables manual limit stops.
NOTE: Programming preset 92 (25) disables the scan limit stops until preset 93 (26) is set. Preset 92 is the left scan limit and preset 93 is the
right scan limit.
Limit Stops Menu
The manual pan limit stops can be set at the controller using the Limit Stop menu:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Limit Stop.
3. Press the Iris Open button to enter the Limit Stop menu.
4. Move the cursor to Set Scan Limits, and press the Iris Open button. PRESS IRIS OPEN TO SET LEFT LIMIT appears.
5. Move the pan and tilt to the desired left limit position, and press the Iris Open button to set the left manual limit. PRESS IRIS OPEN
TO SET RIGHT LIMIT appears.
6. Move the pan and tilt to the desired right limit position, and press the Iris Open button to set the right scan limit.
7. Exit the Limit Stop menu.
Clear Scan Limit Stops
To clear the scan limit stops, move the cursor to Clear Scan Limits and press the Iris Open button. The cursor will flash to an asterisk (*)
briefly to indicate the limits have been disabled.