Filter
Top Products
18 C1680M (1/06)
MOUNTING THE TRANSMITTER INTO AN EH3512/EH3515 SERIES
ENCLOSURE
The following procedure provides instructions to mount the FT8301A transmitter into an existing
EH3512/EH3515 Series enclosure installation.
To mount the transmitter into an EH3512/EH3515 Series enclosure, do the following:
1. Using a small Phillips screwdriver, remove the left and right wall-mounting brackets that are
attached to the transmitter by loosening the four 4-40 x 0.25-inch Phillips pan head screws
(two screws each side).
2. Using the left- and right-mounting EH3500 brackets and the four 4-40 x 0.25-inch Phillips pan
head screws and lock washers supplied in the EH3500 Series accessory kit, attach the
brackets to the transmitter (refer to Figure 8). Note that the left- and right-mounting brackets
are marked L and R, respectively, to indicate the side of the transmitter to which each bracket
should be mounted.
Figure 8. Attaching EH3500 Brackets to FT8301A Transmitter
3. Disconnect power to the enclosure.
4. Unlatch and open the lid of the enclosure.
5. Disconnect power and video cables from the connectors on the camera.
If the enclosure is wired with conduit, skips steps 6-8 below and proceed to step 9. If the
enclosure is wired without conduit, proceed to step 6.
6. Pull the power and video cables out of the two glands at the bottom rear of the enclosure.
7. Remove the two glands at the bottom rear of the enclosure.
(4) SCREWS, 4-40 X 0.25-INCH,
PHILLIPS, PAN HEAD WITH LOCK WASHER
R