Filter
Top Products
C1680M (1/06) 29
8. Mount the transmitter into the back box as follows (refer to Figure 19):
NOTE: In Figure 19, the pan bracket is removed from the back box for illustration purposes only.
You do not need to remove the pan bracket from the back box.
a. Do either of the following:
• If the dome is a DF5 dome, align the inner slot of the DF5/DF8 bracket with the slot
in the pan bracket of the back box.
• If the dome is a DF8 dome, align the outer slot of the DF5/DF8 bracket with the
slot in the pan bracket of the back box.
b. Place the camera into the back box at the desired viewing angle.
c. Insert the stud on the tilt bracket into the aligned slots of the pan bracket and the DF5/
DF8 bracket.
d. Reinstall the flat washer, lock washer, and nut on the stud of the tilt bracket but do not
tighten the nut.
e. Adjust the viewing angle of the camera as necessary.
f. Tighten the nut on the stud of the tilt bracket using the 7/16-inch wrench.
Figure 19. Mounting FT8301A Transmitter into DF5/DF8 Pendant Dome
PAN BRACKET
(REMOVED FROM
BACK BOX FOR
ILLUSTRATION
PURPOSES ONLY)
DF5/DF8 BRACKET
OUTER SLOT (DF8 ONLY)
INNER SLOT (DF5 ONLY)
TILT
BRACKET