Filter
Top Products
28 Pelco Manual C673M (2/01)
TIMER PROGRAM
Figure 17. Timer Program Illustration
This is where you set the program number, day of the week, starting and ending times, and
the recording mode. (Refer to the
Timer Recording
section for more detailed information
and procedures.)
(program number) This number identifies the program (eight maximum). If the recording
times of two programs overlap, the higher program number has priority.
DW Day of the week. DAY is used to record at the same time every day.
SPL (special) uses the start/end days selected with SPECIAL DW at
the bottom of the screen. HLD is used to control recording on holidays
(20 maximum).
START/END The VCR uses a 24-hour display for starting and ending recording
times. 00:00 indicates midnight, 12:00 is noon, and 15:00 is 3 p.m. An
indicator between the START and END columns shows that recording
continues to the following day.
HR This is the recording mode. SKIP indicates that timer recording is not
performed during the set period. Recording mode varies by the TAPE
LENGTH set in the First Time Set Up menu.
00448
<TIMER PROGRAM>
SPECIAL DW MON-
PROGRAM NUMBER
DAY OF THE WEEK
RECORDING START TIME
RECORDING END TIME
NEXT DAY INDICATOR
RECORDING MODE DISPLAY