Filter
Top Products
38 Pelco Manual C673M (2/01)
RECORDING MODE
Pressing the REC/PLAY MODE button switches the recording mode in the following order:
• For T-120 tape: 6H, L18H, L30H, 48H, 72H, 96H, 120H, 168H
• For T-160 tape: 8H, L24H, L40H, 64H, 96H, 128H, 160H, 224H
Table D. Recording/Playback Times
Recording Mode T-120 T-160
2H* 2:00 2:40
6H 6:00 ---
8H --- 8:00
L18H 18:00 ---
L24H --- 24:00
L30H 30:00 ---
L40H --- 40:00
48H 54:00 ---
64H --- 72:00
72H 78:00 ---
96H 102:00 104:00
120H 162:00 ---
128H --- 136:00
160H --- 168:00
168H 174:00 ---
224H --- 232:00
* Playback only
RECORDING CHECK FUNCTION
When the VCR is recording, press the REC CHECK button for more than 1.5 seconds and
then release. The tape rewinds a little and then the VCR plays back the recording just
made. When the tape reaches the spot where you pressed REC CHECK, the VCR starts
recording again.
AUDIO RECORDING/PLAYBACK
Audio will not be recorded if cables are not connected to the AUDIO IN connector or the
microphone is not connected to the MIC IN jack.
The 2H (playback only), 6H, and 8H modes and L18H, L24H, L30H, and L40H modes are
for audio recording and playback on the linear track. Normal sound is played back only
when a tape recorded in these modes is played back in its respective mode.
The lengthier the recording mode, the poorer the sound quality. In L30H and L40H modes,
sound quality is such that speech can be heard.
REPEAT RECORDING
With this function, when the tape reaches its end during recording, the VCR rewinds the
tape and starts recording again. Table E shows what happens automatically when the tape
ends during recording.
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select CLOCK/FIRST TIME SET UP, and then turn the SHUTTLE
ring right. The First Time Set Up menu appears.
3. Turn the JOG dial to select TAPE END, and then turn the SHUTTLE ring right.
4. Turn the JOG dial to select REPEAT or ALARM•PROT, and then turn the SHUTTLE
ring right. Refer to Table E. The repeat indicator on the fluorescent display lights.
5. Press the MENU button. The day and time display appears on the screen.