Filter
Top Products
44 Pelco Manual C673M (2/01)
ALARM RECORDING
When an alarm occurs, the VCR switches to alarm recording.
• Set the alarm recording mode and alarm recording period in the Recording Set Up
menu. Refer to the
Recording Set Up
Menu section for field definitions and additional
information and the
Programming for Alarm Recording
section for instructions.
• The index signal is recorded automatically when an alarm recording begins (INDEX
indicator flashes on the fluorescent display).
• Even if an alarm recording is happening, a new recording starts when the second
alarm signal is input. (However, if the interval between two alarm recording start times
is too short, the second signal may not be detected during skip or index search. Refer
to Table G.)
Table G. Minimum Interval Between Recordings
Alarm Recording Minimum Interval Between Two
Mode Alarm Recording Start Times
6H (8H) Approx. 15 seconds
L18H (L24H) Approx. 2 minutes
L30H (L40H) Approx. 2 minutes
• An alarm recording continues until its end during timer recording, even if the timer
recording end time is reached.
• An alarm recording is cancelled if the tape reaches its end.
Figure 23. VCR Switches to Alarm Mode
ALARM RECORDING CONNECTION
You can confirm an alarm from a distance by connecting the ALM OUT terminal to an
existing alarm system panel or other external device, such as a buzzer. Refer to Figure 3.
Alarm signal input
L30H
Recording
Recording
Alarm Recording
10 min.
00471