Filter
Top Products
30 Pelco Manual C673M (2/01)
REAR TERMINAL MENU
Figure 19. Rear Terminal
Menu
Table B. Call Out/Tape End
CALL OUT Sets the call signal output at the end of the tape. Turns on or off the
signal coming from the CALL terminal when the end of the tape is
reached during recording. If a problem occurs during recording, a call
signal is output from the CALL terminal on the rear panel regardless of
the CALL OUT setting.
• WRNG•TAPE END – The VCR outputs a call signal at the end of
the tape when recording or when a malfunction occurs when
recording. What the VCR does when the tape ends depends on
the setting for TAPE END in the First Time Set Up menu.
• WRNG•REMAIN – The VCR outputs a call signal when the tape
has about nine minutes left (in 6H mode) during recording or
when a malfunction occurs during recording.
• WRNG – The VCR outputs a call signal only when a malfunction
occurs during recording.
CLOCK OUT Sets, at the CLOCK OUT terminal, the number of frames or fields
being recorded (depending on the recording mode).
1. First, set the recording mode for the CLOCK OUT pulse output in
the Rear Terminal menu.
• REC – When recording in any mode
• T/L REC - When recording in time-lapse mode (L18H – 224H
or 0H)
2. Second, select the frequency interval by turning the JOG dial,
switching the display in the following order: 1, 2, 3, 4, 5, 10, 15,
20, 25, 30, 50, 60, F (field), 1. The numbers from 1 to 60 indicate
the number of frames at 6H recording mode and the number of
fields at time-lapse recording modes. (One frame consists of two
fields.) One field is selected when set to F (field).
CALL OUT
setting
TAPE END
setting
STOP
REWIND
REPEAT
WRNG•TAPE END
Outputs a call
signal at the end of
the tape.
Outputs a call
signal at the end of
the tape for two
seconds.
Same as above
Outputs a call
signal at the end of
the tape.
Outputs a call signal
at the end of the
tape for two
seconds. Tape
rewinds and
recording continues.
WRNG•REMAIN
Outputs a low
active signal
three minutes
before the tape
ends.
Same as above
Same as above
Same as above
Same as above
WRNG
When a
malfunction
occurs in the
VCR during
recording, a call
signal is output.
Same as above
Same as above
Same as above
Same as above
ALARM
•PROT
When there
are alarm
recordings
during
recording
When there
are no alarm
recordings
during
recording
00450
<REAR TERMINAL>
CALL OUT WRNG•TAPE END
CLOCK OUT REC-1
MODE OUT REC
REC IN SERIES