Filter
Top Products
32 Pelco Manual C673M (2/01)
MAINTENANCE MENU
Refer to the Maintenance section for instructions and procedures.
FIRST TIME SET UP MENU
NOTE:
Quasi v-sync must
be set OFF for some multi-
plexers to work properly.
With the Pelco MX4000
Series Genex Multiplexer,
setting quasi v-sync on or
off has no apparent effect
on playback.
NOTE:
To stop the buzzer,
press the MENU button
once. If the Main menu ap-
pears, press MENU again to
exit the menu. When the
VCR is locked, press the
LOCK button to unlock the
VCR, then the buzzer stops.
Figure 20. First Time Set
Up Menu
00451
<FIRST TIME SET UP>
TIME DATE ADJUST
TAPE END STOP
QUASI V-SYNC ON
VIDEO MODE AUTO
TAPE LENGTH T-120
BUZZER WRNG
RS-232C
TIME DATE ADJUST Sets the time, date, and daylight savings time settings. Refer
to the
Set the Day and Time
section for the procedure.
TAPE END Sets the VCR’s state of operation when the tape runs out
during recording, as follows:
• STOP – The tape stops. “End” appears on the
fluorescent display and “TAPE END” on the monitor.
When CALL OUT is set to WRNG•TAPE END, a call
signal is output from the CALL OUT terminal.
• REWIND – Rewinds the tape to the beginning and stops
(except during timer recording). When CALL OUT is set to
WRNG•TAPE END and a tape reaches its end, a call signal
is output for two seconds from the CALL OUT terminal.
• REPEAT – Rewinds the tape to the beginning and resumes
the recording. When CALL OUT is set to WRNG•TAPE
END and a tape reaches its end, a call signal is output for
two seconds from the CALL OUT terminal.
• ALARM•PROT – (Alarm Protection) If alarm recordings
are on the tape and the tape stops, “End” appears on
the fluorescent display and “TAPE END” on the
monitor. When CALL OUT is set to WRNG•TAPE END,
a call signal is output from the CALL OUT terminal. If
there are no alarm recordings, the tape rewinds and
recording continues.
QUASI V-SYNC Sets quasi v-sync on or off.
• ON – Quasi v-sync signal is inserted on the video output
signal when in the special playback modes (still, slow
motion, reverse, fast playback, and speed search) and
during playback in modes L18H through 224H and 0H.
• OFF – Quasi v-sync signal is not inserted.
VIDEO MODE Sets the playback and recording color mode.
• AUTO – The VCR automatically switches the circuits
according to the type of input/playback video signal:
color or black and white.
• B/W – Select for recording or playback in black and white.
TAPE LENGTH Sets the tape length.
• T-120 – Select when using T-120 tape.
• T-160 – Select when using T-160 tape.
BUZZER Sets a buzzer to sound a warning.
• WRNG – The buzzer sounds when the VCR malfunctions.
• WRNG•TAPE END – The buzzer sounds when the
VCR malfunctions or the tape reaches its end.
• WRNG•REMAIN – The buzzer sounds when the VCR
malfunctions or the tape has about nine minutes left (in
6H mode).
• OFF – The buzzer does not sound.
RS-232C Accesses the RS-232C menu. Refer to the
RS-232C Menu
section for field definitions.