Philips 26PFL4907 CRT Television User Manual


 
English
15
4 UseyourTV
SwitchingonyourTVandputtingitin
Standbymode
ToTurnPowerOnortoTurnStandbyOn
Touch or press
.
on the front panel or the remote control.
Note
Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low Standby power
consumption.
Adjustingvolume
Toincreaseordecreasevolume
Touch VOL◄(down) / ►(up)on the front panel or press
VOL+/− on the remote control.
Tomuteorunmutesound
Press MUTE on the remote control to mute the sound.
Press MUTE again or VOL+/− to recover the original sound.
Switchingchannels
ToselectChannelsbyusingCH▲/▼orCH+/−
Touch CH▲(up) / ▼(down)on the front panel or press CH+/−
on the remote control.
ToselectChannelsbyusingtheNUMBERbuttons
DigitalTVoperation
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/CableTVoperation
When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note
To select the non-memorized channels, use theNUMBERbuttons.
ChannelnotavailableorNoSignal will appear on the TV screen after the subchannel
broadcast is over.
Audioonly message will appear on the TV screen, when you receive only sound signal.