Philips 26PFL4907 CRT Television User Manual


  Open as PDF
of 67
 
English
38
Preferences
You can set the unit to reduce the power consumption or adjust the
backlight brightness in Location setting.
EasyLink allows you to operate your connected EasyLink device.
Settingyourlocationtohome
Choosing Home gives you full exibility to change predened settings
for picture and sound.
1 Use ▲▼ to select Preferences, then press OK.
2 Use ▲▼ to select Location, then press OK.
Language Location Retail store
Channels
EasyLink Home
Preferences
Network
Reset AV settings
3 Use ▲▼ to select Home, then press OK.
Retailstore
The unit will be set up with predened settings for
retail displays. In this setting, the power consumption
may possibly exceed the limit requirement of the
ENERGY STAR
®
qualication.
Home
This setting is ENERGY STAR
®
qualied.
The unit is set to maximize the energy efciency
for home setting and it can be adjusted through a
choice of picture and sound quality according to your
preference.
Note
• You must set Home. Otherwise, personalized picture and sound settings will not be
memorized after the unit goes into Standby mode.
• If you select Home, E-sticker will not be displayed.
E-sticker
When you set Locationto Retailstore, E-sticker (Electronic Sticker) is
displayed. E-sticker can be Turned Off using procedure below.
1 Use ▲▼ to select Preferences, then press OK.
2 Use ▲▼ to select E-sticker, then press OK.
3 Use ▲▼
to select Off, then press OK.
UsePhilipsEasyLink
Your TV supports Philips EasyLink, which enables one-touch play and
one-touch Standby between EasyLink-compliant devices. Compliant
devices must be connected via an HDMI connector.
One-touchplay
When you connect your TV to devices that support one-touch play,
you can control your TV and the devices with one remote control. For
example, when you press ►(play) on your DVD remote control, your
TV automatically switches to the correct channel to show the DVD
content.
One-touchStandby
When you connect your TV to devices that support Standby, you can
use your TV remote control to put your TV and all connected HDMI
devices in Standby mode. You can perform one-touch Standby using the
remote control from any of the connected HDMI devices.
Systemaudiocontrol
When you connect your TV to HDMI CEC compliant devices, your
TV can switch automatically to play audio from the connected device.
To use one-touch audio, you must map the audio input from the
connected device to your TV. You can use the remote control from the
connected device to adjust the volume.
Remotecontrol(RC)keyforwarding
RC key forwarding allows you to control EasyLink-compliant devices
using your TV remote control.
HDMI-ARC(AudioReturnChannel)
HDMI-ARC allows you to use Philips EasyLink to output TV audio
directly to a connected Audio device, without the need for an additional
Digital Audio cable. Be sure that the device is HDMI CEC and ARC
compliant, and that the TV is connected to the device using an HDMI
cable attached to both HDMI-ARC connectors.
Note
• Philips does not guarantee 100% interoperability with all HDMI CEC devices.
• The EasyLink-compliant device must be Switched On and selected as the source.
 previous next