Philips 26PFL4907 CRT Television User Manual


 
English
5
1 Notice
Trademarks are the property of Koninklijke Philips Electronics N.V. or
their respective owners.
P&F USA reserves the right to change products at any time without
being obliged to adjust earlier supplies accordingly.
The material in this User Manual is believed adequate for the intended
use of the system. If the product or its individual modules or procedures
are used for purposes other than those specied herein, conrmation
of their validity and suitability must be obtained. P&F USA warrants
that the material itself does not infringe any United States patents. No
further warranty is expressed or implied.
P&F USA cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of the
content in this document. Errors reported to P&F USA will be adapted
and published on the P&F USA support website as soon as possible.
Pixelcharacteristics
This LCD product has a high number of color pixels. Although it has
effective pixels of 99.999% or more, black dots or bright points of light
(red, green or blue) may appear constantly on the screen. This is a
structural property of the display (within common industry standards)
and is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove covers
to the inside of the product. Repairs may only be done by Service
Centers and ofcial repair shops. Failure to do so shall void any
warranty, stated or implied.
Any operation expressly prohibited in this User Manual, any adjustments
or assembly procedures not recommended or authorized in this User
Manual shall void the warranty.
FederalCommunicationsCommissionNotice
Thisequipmenthasbeentestedandfoundtocomplywiththelimits
foraClassBDigitaldevice,pursuanttopart15oftheFCCRules.
Theselimitsaredesignedtoprovidereasonableprotectionagainst
harmfulinterferenceinaresidentialinstallation.Thisequipment
generates,uses,andcanradiateradiofrequencyenergyand,ifnot
installedandusedinaccordancewiththeinstructions,maycause
harmfulinterferencetoradiocommunications.However,thereisno
guaranteethatinterferencewillnotoccurinaparticularinstallation.If
thisequipmentdoescauseharmfulinterferencetoradioortelevision
reception,whichcanbedeterminedbyTurningtheequipmentOffand
On,theuserisencouragedtotrytocorrecttheinterferencebyone
ormoreofthefollowingmeasures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio or television technician
for help.
DeclarationofConformity
TradeName: PHILIPS
ResponsibleParty: P&F USA, Inc.
Model: 32PFL4907, 26PFL4907, 22PFL4907
Address: PO Box 2248, Alpharetta, GA 30023-2248
U.S.A.
TelephoneNumber: 1 866 309 0843
Modications
This apparatus may generate or use radio frequency energy. Changes or
modications to this apparatus may cause harmful interference
unless the modications are expressly approved in the User Manual.
The user could lose the authority to operate this apparatus if an
unauthorized change or modication is made.
Cables
Connections to this device must be made with shielded cables with
metallic RFI / EMI connector hoods to maintain compliance with FCC
Rules and Regulations.
Canadiannotice
ThisClassBDigitalapparatuscomplieswithCanadianICES-003.
StandardTelevisionReceivingApparatus,CanadaBETS-7/NTMR-7.
ThefollowingFCC/ICRSS-GenisdescriptionofUSB
WirelessLANadapter.
FCCCaution:Anychangesormodicationsnotexpresslyapproved
bythepartyresponsibleforcompliancecouldvoidtheuser’s
authoritytooperatethisequipment.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
CountryCodeStatement
For product available in the USA market, only channel 1~11 can be
operated. Selection of other channels is not possible.
To maintain compliance with FCC RF exposure requirements, use
only belt-clips, holsters or similar accessories that do not contain
metallic components in its assembly. The use of accessories that do
not satisfy these requirements may not comply with FCC RF exposure
requirements and should be avoided.
FCCRadiationExposureStatement
This equipment is compliance with SAR for general population/
uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had been
tested in accordance with the measurement methods and procedures
specied in OET Bulletin 65 Supplement C. This equipment should
be installed and operated with minimum distance 2.5cm between the
radiator & your body.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device.