Philips 32PFL4507 Flat Panel Television User Manual


  Open as PDF
of 38
 
English
13
Note
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press or MENU/EXIT during autoprogram, this setup of TV channels will be
canceled.
• The initial autoprogram function can be executed for either Antenna or Cable only
once. When you change the connection (Antenna / Cable), set Autoprogram again.
➠
p.20
• If there is no signal Input from the antenna terminal and no operation for several
seconds after you Turn On the unit, helpful hints appears. Follow the instructions listed
on the TV screen.
Initialsetup
Nochannelisregistered.
TryAutoprogramagain?
Verifythatyouhaveacableconnectedtothe“ANTENNAIN”jack
onthebackoftheTV,thechannelinstallationprocess
searchesthisconnection.Ifyouareusingacableorsatellite
box,pleaseconfirmtheinputwhichyouhaveconnectedto
theboxandpress“SOURCE”keyontheremotecontrolto
selecttheappropriatesourceinput.
Retry
Later
Select OK Skip
After an initial setup is completed...
• If you want to scan the channels automatically again.
Autoprogram
➠
p.20
• You can add the desired cable and Analog channels
unmemorized by autoprogram.
Addchannels
➠
p.21
• If you want to change to another language.
Language
➠
p.27
• If you want to change the location setting.
Location
➠
p.27
• If you want to restore the picture setting.
Settingsassistant
➠
p.19
 previous next