Philips 32PFL4507 Flat Panel Television User Manual


  Open as PDF
of 38
 
English
21
• When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
Autoprogram
Pleasewaitwhilethesystemisscanningforchannels.
Autoprogrammingmaytakemorethan20minutesto
complete.
75%
Digital channels
10 ch
Analog channels
6ch
Exit
Note
• After setting Autoprogram, using CH+/−skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press or MENU/EXIT during autoprogram, the setup of TV channels will be
canceled.
• Even if Autoprogram is completed, the channel setting will be lost if the AC power
cord is unplugged before the unit goes into Standby mode by pressing
.
• The PIN Code will be required once you set a PIN code in the Childandratingslock.
➠
p.23
• If you want to change your PIN code, follow the instruction of ChangePIN.
➠
p.25
Channellist
The channels selected here can be skipped when selecting the channels
using CH+/−.
Those channels can still be selected with theNUMBERbuttons.
1 Use ▲▼ to select Channellist, then press OK.
2 Use ▲▼ to select the channel you want to remove, then press
OK.
Picture DTV 11.1
Sound
Highlightchannelsfor
ChUp/Downkeyselection.
DTV 11.2
Setup
DTV 11.3
Features
Language
USB
ChSelect Watch/Skip Back
• The channel display for the removed channel darkens. You will
not be able to select the channel again using CH+/−.
• To reactivate a removed channel, use ▲▼ and press OK. The
registered channels are highlighted.
• When you remove a main channel, its subchannels are removed
as well.
Note
• The channel with DTV indicated on the display is ATSC. Otherwise the channel is
Analog TV.
Addchannels
This function lets you add the off the air Analog TV or Analog Cable
channels that were not added by the autoprogram due to reception
conditions during the initial setting.
1 Use ▲▼ to select Addchannels, then press OK.
2 Use theNUMBERbuttons to enter the number of the channel you
want to add, then press OK.
Picture Add channels
Sound
Foranalogchannels,selecta
channeltobeaddedusing
numberkeys.
Fordigitalchannels,youmust
performAutoprogramfunction.
Setup
Features
Language
USB
ChChange Back
Note
• If setup completes successfully, Addedtothechannellist. is displayed.
• If external Input is used, it is not possible to register the channel and Unavailable will be
displayed on the TV screen.
• Some channels cannot be selected by CH+/−. Use theNUMBERbuttons to select
the memorised channels.
Antennaconrmation
DigitalTVoperation
This function lets you check the Digital signal strength of each channel.
1 Use ▲▼ to select Antenna, then press OK.
2 Use theNUMBERbuttons or CH+/−to select the channel for
which you want to check the Digital signal strength.
Picture Back
Sound
Setup
Current 50
Max 50
Features
Language
USB

ChChange
Note
• If the channel is set to Analog channel or external Input, you cannot conrm the
antenna condition.
 previous next