Filter
Top Products
18 FIRST INSTALLATION
English
Note: if you press <EXIT> during the scanning process, you
interrupt the scanning and go back to the previous screen. In
this case, none of the channels found are stored.
Once scanning has been successfully completed, a
completion message is displayed.
- Press <OK>; a new screen appears, with a message
indicating that a search for new software is in progress.
- Press <EXIT> to stop searching and tune the receiver to
the first channel in the main TV list.
- Alternatively, wait for software detection, and then
proceed as described in paragraph
11.5.4.2.
5.2.2 Setting the correct time for summer
or winter season
Summer and Winter time changes require the manual setting
of the “Time Offset”. Refer to chapter
11.5.3 of the user
manual to set the “Time Offset” menu option to the
appropriate value:
- For summer season it should be set to GMT+2
- For winter season it should be set to GMT+
1
5.3 Sear
ch failur
e
In case of channel search failure, a message is displayed.
- Press <EXIT> to go back to either the First Installation or
Antenna Configuration screen.
Before starting a new scanning
The following checks are recommended to recover adequate
signal quality and strength:
• Check the antenna cable.
• Then check the antenna connection to your receiver
(see chapter 4).
• Then change the pointing of your antenna so as to
maximize the level of the signal quality and strength
bargraph indicators, and then fasten your antenna
according to the antenna user manual instructions.
- When the signal strength and quality is adequate, press
<OK> to launch a new search.
If the failure message appears again, refer to the
Troubleshooting chapter to find out the reason for failure.
For a proper diagnosis and installation check, call your installer.
DSR2011_052005 17/05/05 14:52 Page 18