Filter
Top Products
17
English
Setting Up your DVD/VCR, VCR Operation
Changing the Language
If you want to change the language used on
the TV screen menus,follow the steps below.
1 Press the VCR button,then the MENU but-
ton.
2 Press the PLAY B or STOP C button to
select INITIAL,then press the FF g button.
3 Press the PLAY B or STOP C button to
select LANGUAGE,then press the FF g
button.
4 Press the PLAY B or STOP C button to
select your desired language.
5 Press the MENU button.
A Status Display
To check the Counter,or Clock & Channel
number,press the DISPLAY button.
If the display shows an abnormal read-
ing;
When power is off,press the RESET button
on the bottom of the DVD/VCR with the tip
of a pen etc.The DVD/VCR will reset the all
setting for VCR features including timer
recordings,the clock and the language set-
tings.In this case,you need to reset these set-
tings.
3 If playback does not start automatically,press
the VCR button,then press the PLAY B but-
ton.
4 Press the STOP C button to stop playback
and press the STOP/EJECT A button on the
DVD/VCR to remove the tape.
Note:
– When playing a S-VHS format,you can’t
get the high resolution picture and noise
lines may appear on the picture.
IF A TAPE IS ALREADY IN THE
DVD/VCR
Using the buttons on the DVD/VCR
Just press the PLAY B button on the
DVD/VCR. Power will automatically turn on
and playback will start. (Direct Button
Operation)
Using the buttons on the remote con-
trol
Press the STANDBY-ON button to turn on,
and then press the PLAY B button.
Recording a Video Cassette Tape
1 In stop mode, insert a tape with its record
tab intact into the cassette compartment.
a CST.IN light appears on the front of
DVD/VCR.
2 Press the SPEED button until the desired tape
speed appears briefly.
3 Use the P +/– buttons or the numerical key
pad button to select the TV channel to be
recorded.
4 Press the REC button to start recording.
● If a tape without a record tab is in the
DVD/VCR, the DVD/VCR will eject the tape.
5 Press the PAUSE k button once to pause the
recording temporarily.
6 Press the PAUSE k button again or the REC
button to resume recording.
7 To stop recording,press the STOP C button.
Note:
– Changing tape speed during recording
will cause distortion on the tape.
RESET
button
FRONT SIDE
<BOTTOM VIEW>
Playing a Video Cassette Tape
1 Turn on the TV and set the correct channels
per your DVD/VCR channel.
2 With the DVD/VCR power off,insert a tape
in the cassette compartment.
a Playback will start automatically,if the
tape’s record tab has been removed.
● If the DVD/VCR power was already on,press
the SOURCE button to switch to VCR mode.