Filter
Top Products
36
English
Troubleshooting
If you are unable to remedy a problem by following these hints, consult your dealer or service
centre (HOTLINE).
Solution
– Playback will stop for more than 35 minutes and no
button is pressed.
– Make sure the tape has a record tab.
– Make sure the DVD/VCR is in VCR position.
– Check the TV and the DVD/VCR channel are
similar.
– Make sure the recording start and stop times are
set correctly.
– Make sure the tape has a record tab.
– Make sure the clock is set.
– The DVD/VCR may not perform or continue a
timer recording if the power fails for more than 30
minutes.
– To enable quick play mechanism, the cylinder will
rotate for about five minutes.This is normal.
– Insert a tape,window side up with the record tab
facing you.
– Gently push on the center of the tape when putting
into the DVD/VCR.
– Make sure the power plug is completely connected
to a power outlet.
– Make sure the tape has a record tab.
Problem
The DVD/VCR switches from DVD mode
to VCR mode after 35 minutes
The VCR do not record a TV
program
The DVD/VCR do not perform a
timer
The motor (cylinder) rotates even
when tape playback is stopped
You cannot insert a tape
You cannot remove a tape
DVD/VCR ejects the tape when you
press the REC or TIMER button for a
timer recording.