Filter
Top Products
35
Manually setup universal remote
control
Enter an RC code to setup a universal mode
key (see ‘Universal remote control codes’ on
page 59).
1 Press and hold the universal mode
button (DVD, STB or HTS) and OK
simultaneously.
All four keys light up for one second »
and the key stays lighted.
2 Enter the 4-digit RC code for the device.
3 If the code is accepted, all four keys blink
three times.
The universal mode key is set up. »
4 If the code entered is incorrect, all keys
blink for two seconds. Re-enter the
correct code.
5 When setup is complete, press the
universal mode key to operate the device.
Tip
If the device does not react correctly, repeat •
the setup with another RC code.
• STB: controls a digital receiver or satellite
receiver
• HTS: controls a home theatre system or
anamplier.
Setup universal remote control
Before you use the TV remote control to
control another device, setup the universal
remote control mode.
Note
For some devices, this feature is not •
supported. There is no suitable RC code.
1 Press (Home).
The home menu appears. »
2 Press the Navigation buttons to select
[Setup].
3 Press OK.
The » [Setup] menu appears.
4 Press the Navigation buttons to select [I
nstallation]>[Universal remote control].
5 Press OK.
Follow the on-screen instructions. The »
TV searches for a suitable RC code for
your device.
6 When an RC code is detected, press the
Universal control buttons to control the
device.
The key blinks. Use the remote control »
to control the detected device.
Tip
In universal remote control mode, the remote •
control switches to TV mode after 30 seconds
if no key is pressed.
English
EN