Filter
Top Products
39
4 When complete, press the Navigation
buttons to select [Done].
5 Press OK.
The » [Installation] menu appears.
Note
If you have further problems with the •
reception of your digital broadcast, contact a
specialised installer.
Change startup message
settings
Enable or disable messages that appear at
the startup to indicate whether a channel or
installation update is needed.
1 In the [Installation] menu, press the
Navigation buttons to select [Channel
installation] > [Channel update
message].
2 Press OK.
3 Press the Navigation buttons to select
[On] or [Off].
Startup messages are enabled or »
disabled.
5 Press OK.
Follow the on-screen instructions »
to complete channel update. When
the update is complete, [Done] is
selected and a list of added channels is
displayed.
6 Press OK.
The » [Installation] menu appears.
Test digital reception
If using digital broadcasts, you can check the
quality and signal strength of digital channels.
This allows you to reposition and test your
antenna or satellite dish.
1 In the [Installation] menu, press the
Navigation buttons to select [Channel
installation] > [Digital: Reception test] >
[Search].
2 Press OK.
The » [Search] menu appears.
3 Press:
The • Navigation buttons or Numeric
buttons to manually enter the
channel frequency.
The • Navigation buttons to select
[Search], then press OK to
automatically search for the next
channel.
If the signal quality and strength
is poor, reposition the antenna or
satellite dish and retest.
Select Update channels
to update your current
channel list. Select Re-
install channels to search
and store all channels
again.
e
ls
t
e-
a
r
c
h
s
Re-install channels
Update channels
English
EN