Filter
Top Products
56
The TV menu is in the wrong language.
Change the TV menu to your preferred •
language (see ‘Change language settings’
on page 14).
When turning the TV on/off/to standby, you
hear a creaking sound from the TV chassis:
No action is required. The creaking sound •
is normal expansion and contraction of
the TV as it cools down and warms up.
This does not impact performance.
When the TV is in standby mode, a startup
splash screen is displayed, then returns to
standby mode.
This is normal behavior. The startup •
screen is displayed when the TV is
disconnected from the mains and
reconnected.
TV channel issues
Previously installed channels do not appear in
the channel list:
Check that the correct channel list is •
selected.
No digital channels were found during the
installation:
Check that the TV supports DVB-T, DVB- •
T Lite or DVB-C in your country. See the
listed countries on the back of the TV.
Picture issues
The TV is on, but there is no picture:
Check that the antenna is properly •
connected to the TV.
Check that the correct device is selected •
as the TV source.
There is sound but no picture:
Check that the picture settings are •
correctly set.
There is poor TV reception from an antenna
connection:
Check that the antenna is properly •
connected to the TV.
9 Troubleshooting
This section describes commonly encountered
issues and accompanying solutions.
General TV issues
The TV does not switch on:
Disconnect the power cable from the •
power outlet. Wait for one minute then
reconnect it.
Check that the power cable is securely •
connected.
The TV does not respond to remote control
or side controls when switched on
When the TV is switched on, the front •
LED indicator ashes for about 20 to
25 seconds. This is normal behaviour.
During this time, the TV will not respond
to the remote control or side controls.
When a picture appears on-screen,
the TV responds only to the following
remote control buttons for the rst few
seconds:
+/- (VOLUME +/-), P +/-
(Program +/-),
(MUTE) and (Standby-
On). All buttons can be used when the
front LED indicator stops ashing.
The remote control is not working properly:
Check that the remote control batteries •
are correctly inserted according to the
+/- orientation.
Replace the remote control batteries if •
they are at or weak.
Clean the remote control and TV sensor •
lens.
The standby light on the TV blinks red:
Disconnect the power cable from the •
power outlet. Wait until the TV cools
down before reconnecting the power
cable. If the blinking reoccurs, contact
Philips Consumer Care.
You forgot the code to unlock the child lock
feature
Enter ‘8888’. •
EN