Filter
Top Products
15Use of the menus
Display message
Switch the TV to standby.
The message appears on the screen when the TV is switched on again.
If you selected
Once, the message will disappear from the screen after
about 45 seconds.
If you selected
Continuous, the message will appear on the screen until the
Run menu item in the Message menu is switched to No or until the receiver
is powered off.
The message does NOT appear when Continuous subtitles have been
switched On. See p. 10.
Timers
With the
Timers menu you can make your TV automatically switch to a
specific programme number from standby or switch over to a different
programme number at a specific time.
Do not switch off your receiver with the power key A on the
receiver !
Actual time
If you have installed a TV channel which also broadcasts teletext on
programme number 1 or under the lowest favourite programme number
greater than 1, the time is downloaded from that TV channel.
If this is not the case you have to set the time manually with the digit keys.
The time, (entered manually) is updated every minute and remains until the
TV is switched off with the power key A.
Note: If you entered an incorrect digit, complete the actual time with arbitrary
numbers, then start again. Use 24 hour, or military time.
Programme
Enter with the digit keys the programme number of the TV channel you want
your TV to switch over to. Use 24 hour, or military time !
Start time
Enter with the digit keys the start time of the selected TV programme
number you want your TV to switch over to. Use 24 hour, or military time !
Cancel timer
Select
Cancel Timer and press OK to reset the Start time to --:--
TIMERS
Actual Time
Programme
Start Time
Cancel Timer
Should your remote be lost or broken you can still browse through the TV
channels and A/V sources or change some of the basic picture and sound
settings with the keys in front of the receiver box.
The
PROGRAM - and + keys enable you to select the TV channels or A/V
sources.
The
VOLUME - and + keys enable you to adjust the volume.
Note: If the message
Child Lock ON appears, the child lock must be switched off (with
a remote control) before you can use the
PROGRAM - and + or the VOLUME - or +
keys on the receiver. See p. 14.
Press the
LOCAL MENU key behind the door at the front of the receiver
repeatedly to select
Volume, Brightness, Colour, Contrast, Treble or Bass.
Press the
VOLUME - or + key to adjust the chosen selection.
The selected adjustment automatically switches off when after 10 sec. no action has
been executed.
Keys in front of the receiver box
LOCAL
MENU
VOLUME
PROGRAM