Filter
Top Products
English
RECORDING 39
The following channel numbers are provided for
recording from external sources that are connected to
these jacks on the DVD Recorder:
‘EXT1’ : rear S-Video (Y/C)
‘EXT2’ : rear Video (CVBS)
’EXT3’ : rear component video (YP
B
P
R
)
‘CAM1’ : front S-Video
‘CAM2’ : front CVBS
‘CAM3’ : front DV.
These channels are located between channels 125 and 1
when choosing TV channels at the Recorder while the
Recorder is in TUNER mode.
4 Press RECORD.
‰
RECORD shows on the display.
5 Press 9 STOP to stop recording.
‰ MENU UPDATE is shown on the display.
6 The Index Picture Screen appears showing the most
recent recording.
7 After a short recording on a new disc, a few minutes
will be needed to complete the formatting of the
disc.
Manual audio control
You can control the audio volume recording level of
your DVD Recorder manually.
l In tuner mode, press AUTO/MAN REC
VOLUME on the front of the DVD Recorder. (You
may have to press PANEL to access the front panel
buttons).
‰ The display will show the current audio level, and
MANUAL appears.
l Adjust the recording level with MANUAL 3 or 4
on the DVD Recorder so that the ‘0 dB’ mark lights
up during the loudest parts of the recording.
l Return to automatic audio level control by pressing
AUTO/MAN REC VOLUME again.
‰ The display will show the current disc position,
and
MANUAL disappears.
Note:
When recording from the equipment connected to DV, the
manual audio control is disabled. The AUTO/MAN REC
VOLUME button is active only during TUNER mode or
while recording.
Recording with automatic switch-off (OTR
One-Touch Recording)
1 Insert a recordable DVD+RW disc.
2 Normally, the DVD Recorder displays the contents
of the disc on the screen to see the currently
selected TV channel.
3 Use CHANNEL 3 or CHANNEL 4 (on the
Recorder) or P+, P- or the digit buttons 0-9 (on
the remote control) to select the channel you wish
to record.
4 Press RECORD.
‰ A 30 minute recording will be made.
‰ The end time of the recording shows briefly in
the timer box on the TV screen. The remaining
recording time shows in the status box on the TV
screen and on the display.
5 To increase the recording time in 30-minute
increments, press RECORD repeatedly.
6 Shortly after pressing RECORD, an OTR can be
cancelled by pressing CLEAR.
Timer programming
The DVD Recorder needs the following information for
every programmed recording:
- the date on which the recording is to be made;
- the channel;
- the start and stop time of the recording;
- the recording speed (HQ, SP, LP or EP).
The DVD Recorder stores all the information
mentioned above in a timer block. You can program up
to six timer blocks, one year in advance.
10: 15 pm
SP
CHANNEL
DVD RW
TITLE
CHAPTER TIME REMAIN
-30-40 -10-20 0 OVER-30-40 -10-20 0 OVER
STEREO
RECORD
MANUAL