Filter
Top Products
42
09 Advanced Setup Menu
• SERIAL PORT
Set the RS-232C interface to use with a 15-pin
connector or 9-pin connector. Only a single
type of connector may be used at a time.
Use / (cursor left/right) buttons to
alternate between 15 Pin and 9 pin (Default
setting is 15 Pin).
15 Pin: When connecting to a PC using
a Pioneer or other brand 15-pin
to 9-pin cable.
9 Pin: When connecting to a PC using
a commercial 9-pin cross-cable.
• BAUD RATE
Sets the Baud rate for the RS-232C
interface.
Use / (cursor left/right) buttons to
alternate between 19200 bps and 9600 bps
(Default setting is 19200 bps).
• EXTEND TERMINAL
Use the Extend Terminal to select a switch-
key setting.
Use / (cursor left/right) buttons to
alternate between Standard and User
(Default setting is Standard).
Standard: The unit responds according to
established standard setting
(see pages 68 – 70).
User: The user selects how the
external option key responds.
Press ENTER to activate this
option (see page 46).
• SYNC OUT (DURING SQ)
Use SYNC OUT to determine if a video signal
is sent when the player is not playing video.
Use / (cursor left/right) buttons to
alternate between ON and OFF (Default
setting is OFF).
OFF: Video is output constantly; the
sync signal is ON.
ON: Video is not output except
during playback and when
displaying menu screens (sync
signal is off).
Power On Start
Sets playback mode when power is turned on.
1 Press and hold HOME MENU for one
second.
The screen displays the ADV. SETUP menu.
2 Use the (cursor down) button to
select POWER ON START.
3 Use the / (cursor left/right) buttons
to select a mode other than OFF, then
press ENTER.
When OFF is selected, Power On Start
function is disabled.
4 Use the / (cursor up/down) buttons
to select 1, 2, or 3, then press ENTER.
• If the power is interruputed while saving the ADV. SETUP menu settings during
video playback and the disc is still spinning, the settings are not recoreded.
When disconnecting the power cord, always turn off the main power switch
first (the power indicator is not lit) or use the remote control to set the unit to
Standby mode (the power indicator changes to orange).