Filter
Top Products
Recording
06
66
En
Initializing recordable DVD
discs
DVD-R/-RW discs can be initialized for either
Video mode recording or VR mode
recording.
1
When you first load a blank DVD-RW or
DVD+RW disc, the recorder initializes it for
recording automatically. By default, blank
DVD-RW discs are initialized for VR mode
recording. See
DVD-RW Auto Init.
on
page 124 if you want to change the default to
Video mode.
DVD-R discs are ready for Video mode
recordings out of the box; if you want to use
a DVD-R for VR mode recording, you must
initialize it before recording anything on the
disc.
DVD+RW and DVD-RAM discs can also be
initialized in order to erase the contents of
the disc.
Important
• Initializing a DVD-RW, DVD+RW or
DVD-RAM disc will erase everything
recorded on it. Make sure there is
nothing on the disc that you want to
keep!
• You may not be able to re-initialize a
DVD-RW disc in a different format if it
was originally initialized on an older DVD
recorder.
• Once initialized for VR mode recording,
you can’t re-initialize a DVD-R back to
Video mode.
1 Select ‘Disc Setup’ from the
Home Menu.
2 Select ‘Initialize’ > ‘Video
Mode’, ‘VR Mode’ or ‘Initialize
DVD+RW’.
3 Select ‘Start’.
It takes about 30 seconds to initialize the
disc (except DVD-RAM discs, which can take
up to 1 hour).
Note
1.If a disc was previously finalized on an older DVD recorder, you may not be able to re-initialize and/or initialize
it for Video mode recording.
DVD-R DVD-RW DVD+RW DVD-RAM
HOME MENU
ENTER
Basic
Initialize
Finalize
Optimize HDD
Disc Setup
VR Mode
Video Mode
Initialize DVD+RW
Start
Start
Start
Initialize
ENTER
Initializing Disc
1 min left
Pr 1
DVR540H_WV_EN.book 66 ページ ２００６年２月１６日 木曜日 午後４時３４分