Filter
Top Products
08 Basic Operations
34
En
Plasma Display
(right view)
Channel display
A 125
CBS
STEREO
Watching digital TV channels
Unless you set up digital TV channels that you can
watch under the current conditions, you cannot tune in
those channels. For the procedure, see “Setting up
digital TV channels” on page 44.
Selecting the digital TV input
After confirming that the Mode switch on the remote
control unit has been set to “TV”, press DTV on the
remote control unit to select the input source for digital
TV channels.
Changing channels
Using CH +/– on the remote control unit
•Press CH + to increase the channel number.
•Press CH – to decrease the channel number.
• CHANNEL +/– on the Plasma Display operates the
same as CH +/–.
Using CH RETURN on the remote control unit
Press CH RETURN to switch the currently tuned
channel to the previously tuned channel.
Press CH RETURN again to switch back to the
currently tuned channel.
Using 0 – 9 and • (dot) on the remote control
unit
Select channels directly by pressing buttons 0 to 9. To
select subchannels, also use the • (dot) button.
EXAMPLE
•To select channel 5 (1-digit channel), press 5.
•To select channel 25 (2-digit channel), press 2,
followed by 5.
•To select channel 125 (3-digit channel), press 1, then
2, followed by 5.
•To select subchannel 2.1, press 2, • (dot), then 1.
•To select subchannel 10.1, press 1, 0, • (dot), then 1.
•After entering a channel or subchannel number, you
may press CH ENTER to tune in the channel more
quickly.
CHANNEL +/–
PENDING
PDP5040HD-Eng (28-37) 7/24/03, 1:58 PM34