Filter
Top Products
11 Enjoying through External Equipment
76
En
To delete information about all devices:
1
Press / to select “Delete All”, and then press
ENTER.
2
Press / to select “Delete” and then press
ENTER.
•A confirmation message appears.
•A warning message appears if the selected
device has been preset for recording with the
timer or if its power is on. If you delete a device
that has been preset for recording, its all
presettings are deleted.
3
Press / to select “OK”, and then press ENTER.
Setting up for i.LINK standby
Use the following procedure to enable data transfer
between multiple i.LINK devices even when the system
is in the standby mode.
1
Press HOME MENU.
2
Press / to select “DTV Setup”, and then press
ENTER.
3
Press / to select “i.LINK Setup”, and then
press ENTER.
4
Press / to select “i.LINK Standby”, and then
press ENTER.
5
Press / to select “Enable”, and then press
ENTER.
6
Press HOME MENU to exit the menu.
•With “Enable” selected, the system relays data
between multiple i.LINK devices even when in the
standby mode; the i.LINK circuits are energized in
that mode.
•With “Disable” (factory default) selected, less power
is consumed when the system is in the standby
mode; however the system does not relay data
between multiple i.LINK devices. When i.LINK de-
vices are not in connection, select “Disable”, result-
ing in less power consumption.
In standby mode
i.LINK device Media Receiver i.LINK device
No data relay
PDP5040HD-Eng (65-80) 7/24/03, 2:00 PM76