Filter
Top Products
Additional information
16
161
En
Hints on installation
We want you to enjoy using this recorder for years to
come, so please bear in mind the following points when
choosing a suitable location for it:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such as a table,
shelf or stereo rack.
Don’t...
Use in a place exposed to high temperatures or
humidity, including near radiators and other heat-
generating appliances.
Place on a window sill or other place where the
recorder will be exposed to direct sunlight.
Use in a dusty or damp environment or in a room
where it will be exposed to excessive cigarette smoke.
Place directly on top of an amplifier, or other
component in your stereo system that becomes hot in
use.
Use near a television or monitor as you may
experience interference — especially if the television
uses an indoor antenna.
Use in a kitchen or other room where the recorder
may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover with cloth —
this may prevent proper cooling of the unit.
Place on an unstable surface, or one that is not large
enough to support all four of the unit’s feet.
Moving the recorder
If you need to move the recorder, first remove the disc, if
loaded, and close the disc tray. Next, press
STANDBY/
ON
to switch the power to standby, checking that the
POWER OFF
indication in the display goes off. Wait at
least two minutes. Lastly, disconnect the power cord.
Never lift or move the recorder during playback or
recording — discs rotate at a high speed and may be
damaged.
Resetting the recorder
If you need to, you can reset the recorder to all its factory
settings.
1 Make sure that the recorder is on.
2 Using the front panel controls, press and hold
(Stop) and press
STANDBY/ON.
The recorder turns off with all settings reset.
DVRLX60D_WV_EN.book 161ページ ２００７年４月２４日 火曜日 午後７時５８分