Filter
Top Products
Connections & Setup
_f_J_dwmr_#m.PmN_rcJK_W_7_rttm4rl_m
k_o_,_t _ wI m_c _ abkmer _ _ _ wa_ TV.
Wht<_ _1 is your "fV tuned to v/hen usk_J
_02
._ 03
3.
Highlight the channel to which you have to tune your TV in order to see
cable programnling, and press OK (a screen appears l_minding you to
connect your G-LINK cable to your TV and cable box).
Notes: C'bamze/ 03 l_ tbe mos! cnnnnou
Choose lqden l/Mf_7_"iJ_rottr cable box is conm,cted to yonr TVwitb
andio/video cables instead q['a coaxial cable. Go to page" 7Jbrpictures (_/"
thes_ _cclblt_s.
4. Highlight your bnmd o[ cahle box. and press OK.
If your brand isn't listed, highlight Not Listed and press OK.
,
Make sure your cable box is on.
Tune flae cable box to channel 02 (use tim remote control that came with
your cable box, or press the channel buttons on the cane box).
Press OK (the GUIDE Plus+ system starts testing codes).
Important Note: When code testing is in progress, don't touch your TV,,
VCR, cable box or any of the remote controls for theseproducts.
.
Look at your cable box. If it is still on and changed to channel 09, the test
was successful. Highlight Yes, and press OK (STEP 3: Configuring for a VCR
appears).
ff your cane box didn't change to channel 09 or turned itself off, you have
two choices: No and Test this code again.
Test this code again: If you think the TV, tire cable box, or any of the
remote controls might have been touched or bumped during the test,
highlight Test this code again and press OK (the GUIDE Plus+ system runs
dae same set of codes).
No: If you don't think the test was interrupted, highlight No and press OK
(GUIDE Plus+ system tests the next code).
Repeat the previous instructions until the TV finds the correct cable box
code. Follow the instructions on the screen.
Note: I/'the TV can ?find your cable box code, a troubleshooting
checklist appears. Carefully review each checklist and follow the
inMrTlclions on the screen.
Chapter 1 17