Filter
Top Products
Using the Remote Control
Using Direct Entry
1. Turn on the component you want tile remote to operate.
2. Look tip tile brand and code nuh_ller(s) for the component on tile code list on page 26.
3. Press and hold the component button that corresponds to the component you want the
remote to operate (VCR1, DVD, etc.)
4. Enter the code Dora the code list.
5. Release tile component button.
6. Press ON*OFF to see if tile component responds to tile remote conlnlands. If it doesn't, try
pressing tile component button and then ON-OFF again.
7. If you get no response, repeat these steps using the next code listed for your brand until tile
component responds to tile remote conlnlands.
The buttons might
operate differently for
other components,
especially when you're
using another
eomponent's menu
system.
How to Use the Remote After You've
Programmed It
Once the remote has been programmed successfully, you are ready to use it to control your
components. To operate the component:
1. Press tile component button (TV, VCR1, VCR2, DVD, AUX, or SAT-CABLE) to set the remote
to operate the component.
2. Press ON-OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Note: If you keep pressing buttons and nothing happens, the remote isprobably in the
wrong *node. You must press the component button that matches the component you
want to operate (i.e., if you want to operate the VCR, press VCR1 on the remote control to
put the remote in VCR mode.)
Chapter 2 25