Filter
Top Products
Connections & Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUII)E Plus+ system (tile on-screen interactive program guide) to
work with your VCR and, or cable box
Cable Box- If your 'Ix,' is connected to a cable box you must connect tire G LINK cable to rece ve
TV program listings Ik)r y()ur area, :ill(.]tO tune directly to a channel when the program guide is on
your TV screen.
VCR- If your "IA'is connected to a VCR and you don't connect the G-LINK cable, one-touch VCR
ecr)rding won't work. The other features of the guicle will work properly.
G-LINK wands
How to Find the Remote Sensor
You have to place the G LINK wands in fi'ont of the remote sensor on the VCR and/or cable box.
Sonre cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn't
labeled on your VCR and/or cahle box, you need to use the remote control that came with the VCR
and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but the one that came with the
cable box and/or VCR to wbich you're attaching the G-LINK cable) so that it is touching the
front of the component.
3. Slowly nrove the remote control across the front of tl_e component (VCR or cable box) while
you press the power button on and off. You must press and release the power button each
time you move the remote (bolding down the button won't work).
4,
When the component turns on, you've located the renrote sensor.
If you don't have both a
cable box and a VCR
connected to your T_,
just coil the cable of the
extra G-LINK wand with
a twist tie and leave it
behind the TV
Placing the G-LINK Wands
Place the G-LINK wands in front of the renrote sensor on your VCR and/or cable box approximately
one inch away from the remote sensor (see instructions below).
TV(ba©kpanel)
Connect to G-LINK iack
/_ mortthe ba_:k of the _. _'_l I_ _.
Chapter 1 13