Filter
Top Products
Using the Remote Control
To turn off all the
RCA, GE, and
PROSCAN
components that are
connected to the TV,
press ONoOFF twice
within two seconds.
Th_ _ature on_
works with mostRCA,
GEandPROSCAN
produc_.
PAUSE If you're operating a VCR or DVD Player with the remote control, press PAUSE when the disc
or videotape is playing to pause playback.
PLAY If you're operating a VCR or DVD Player, plays tl_e disc or videotape.
REC*¥CR+ When the GUIDE Plus+ program guide is on the screen, press REC-VCR+ to program
your VCR to record it program. If tile remote is in VCR mode. press REC°VCR+ to start recording
REVERSE If you're operating a VCR or DVI) Player with the remote control, press REVI_RSEto go
backwards on a disc or videotape.
SAT°CABLE Puts the remote in SAT°CABLE mode. If you set up the Auto Tuning lOature (Chapter
3), pressing the SAT*CABLE button automatically tunes the TV to the correct channel.
SKIP If you press this button before you change the channel, the TV waits 30 seconds and
automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if
you press SKIP txxo times before you change tl_e channel, the TV waits 60 seconds and automatically
turns back to the original channel).
SOUND Displays the AUDlO PROCESSORmenu.
STOP If you're operating a VCR or DVD Player, stops playing the disc or videotape.
'IV Turns on the TV and puts the remote in TV mode. Also displays channel information.
YER1 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR1 button automatically tunes the TV to the correct channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR2 button automatically tunes the TV to the correct channel.
VOL (up and down) buttons Decrease or increase the TV's volume.
WHO-INPUT In TV mode, press WHO-INPUT to toggle through the available Video Input channels
(VID/SVID and the current channel). In SATmode, press to select available channel lists.
Using the WHO.INPUT Button
Use the WHO-INPUT button to toggle through the available input sources (VID and the current
channel) and view the content from the component you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the component is
turned ON.
2. Press WHO-INPUT to tune to the available input source and view the component.
3. Press WHO.INPUT again to rune back to the channel you were previously watching.
Chapter 2 23