RCA HDLP50W151 Flat Panel Television User Manual


 
Connections & Setup
30 Chapter 1
What to Expect
The next time you turn on your TV after setting up the GUIDE Plus+ system, the guide will
appear on the screen. The following examples explain what you might see:
If all of the program information has been sent to your TV, the GUIDE Plus+ system appears
with all of your TV program listings.
If the program information hasn’t been sent to your TV yet, an outline of the GUIDE
(without TV program listings) will appear on the screen. Program information is usually sent
to your TV at night.
If more than one cable company services your area, you may be prompted with a Channel
Mapping screen after the first GUIDE Plus+ system download. You will need to identify your
cable company by selecting the correct channel numbers for the stations in question.
Features of the GUIDE Plus+ system are explained in Chapter 3.
To clear the guide from your screen, press CLEAR or GUIDE on the remote control.
Changing Channels
Depending upon the type of signals you have connected to your HDTV, you might notice that
the channels change slower than you’re used to. This is perfectly normal. Your HDTV is able to
interpret and display both analog (NTSC) and digital (ATSC) signals and the digital subchannels
(when available). Also, you may notice that the size of the Channel Banner changes as you scan
through analog and digital channels.
Tur ning the TV On and Off
Your HDTV is equipped with a lamp system that is part of the technology that enables us to
design such a thin, light-weight TV with a crisp, bright picture. To prolong the life of the lamp,
the TV must properly warm up and cool down. Therefore, the TV doesn’t turn off completely
right away— it fades from blue to black. In case you accidentally turn off the TV, you can still
turn it on while the screen is blue. Once the screen goes black, the lamp’s cool-down cycle
begins (you may hear a slight humming noise as the lamp cools down). If you try to turn on the
TV during the cool-down cycle, the power light on the front of the TV will blink to alert you that
you need to wait (when the cool-down cycle is complete—about 30 seconds—the TV turns back
on automatically).
Next Steps
Now that you’ve finished the Assisted Setup, you’re ready to watch TV. This might be a good time
to program your remote control. The remote control that came with this TV can be programmed
to operate other components. Go to the next chapter to find out how to program your remote.
• Chapter 2: Using the Remote Control
• Chapter 3: Using the TV’s Features
• Chapter 4: Using the TV’s Menu System
• Chapter 5: Reference
1614682A.03_cx_8.22 9/18/03, 5:28 PM30