Filter
Top Products
References
Chapter 5 81
• Make sure there is a tape in the VCR and that the VCR is connected properly.
• Make sure VCR is tuned to the line input. Don’t change channels.
• Be sure that you set up the VCR in the GUIDE Plus+ Setup menus. If you don’t complete the Configuring for a VCR steps successfully,
the Record option won’t be available. Go to page 28 for detailed instructions.
• If a cable box is attached to your TV, make sure you set it up correctly in the GUIDE Plus+ Setup menus. Go to page 27 for detailed
instructions.
• The guide comes up each time you turn on the TV. You can disable the guide by going to the Auto-on feature in the GUIDE Setup
menu and select Review Options.
Doesn’t tune to correct antenna input
• Because of occasional irregular data, the guide may inadvertently tune to the incorrect antenna input in the video window or when
using CLEAR to exit the guide.
The Remote Control Doesn’t Work
• Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
• Maybe the remote isn’t aimed directly at the component (TV or VCR) that you’re trying to operate.
• Maybe remote is not in TV Mode. Press the TV button so the remote controls the TV.
• Maybe batteries in remote are weak, dead, or installed incorrectly. If batteries are weak, you will not be able to activate backlighting
on the remote; instead, backlight will blink once when activated. Put new batteries in the remote. (Note, if you remove the batteries,
you may have to reprogram the remote to operate other components.)
• When using the Learning feature, do the learning process in low light areas to prevent natural light and fluorescent light interfering
with the infrared signals.
• For Volume Punchthrough, remember to program the AUDIO button on the TV’s remote control to operate your audio receiver or
amplifier. Go to page 34 for instructions. If you can’t program this remote to operate your audio receiver, Volume Punchthrough
won’t work.
Problems with V-Chip/Parental Controls
The rating limits don’t work
•You must lock the settings. Go to the MAIN MENU (press MENU on your remote), select Parental Controls (press 5 on your remote),
select Lock TV (press 1 on your remote).
I don’t remember my password and I want to unlock the TV
• If you forget your password, simultaneously press and hold MENU/OK on the television and VOL down on the remote for 3 seconds.
Nothing appears on the screen, Parental Controls simply unlock and you can re-enter a password via Lock TV.
The V-Chip won’t let me watch a program even though it’s not rated as violent.
• Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set V-Chip Unrated to View separately
in order to view movies with an NR rating.
Problems with 1394 Recording/Playback
• Make sure the 1394 components are not looped. See page 16.
• If the network speed seems slow, make sure the 1394 component that has the fastest speed is first at point of connection to TV.
Check component manual’s for network speed. See page 16 for more information.
• Make sure the program is digital (ATSC) or no recording will take place.
• If a program is not recorded, it could be the 1394 component enforces copy protection standards.
• If you cannot find the program you recorded, channel through the subchannels.
1614682A.07_refs_8.8 9/18/03, 5:30 PM81