Filter
Top Products
32
Chapter 4: Commercial Interface Menus
Power Management
- Auto Power On : This function sets the power state when AC power is applied to the TV.
+ Off : TV will go to stanby mode
+ On : TV will turn on
+ Last : TV will resume the state it was in before AC power was removed.
- Auto Power Off : This function assigns the amount of time an inactive TV will remain on. It can be used by
your facility to save energy.
- Power Always : If Power Always menu is on, TV can not be turned off.
- No Signal Power Off : If there is no signal on the TV for 15 minutes or more, this function turns off the TV
automatically.
- CH Hold : If this function is on then TV will turn off when CH key is held for 4 seconds on an analog pillow
speaker.
- Power Off in Channel List : If this function is on then TV will turn off when CH+ key is pressed on last
channel.
- Pillow Initial Volume : TV is configured to Initial Volume when TV is in pillow speaker mode.
- Pillow Min Volume : TV limit minimum volume when TV is in pillow speaker mode.
- Pillow Max Volume : TV limit maximum volume when TV is in pillow speaker mode.
Pillow Speaker
(available on Hospital models only.)
Back
Off
Off
20
0
100
FF GG
FF GG
FF GG
FF GG
FF GG
D E
Move
F G
Adjust
Menu
CH Hold
Power Off in Channel List
Pillow Initial Volume
Pillow Min Volume
Pillow Max Volume
Back
Off
Off
Off
Off
FF GG
FF GG
FF GG
FF GG
D E
Move
F G
Adjust
Menu
Auto Power On
Auto Power Off
Power Always
No Signal Power Off
Exit
Commercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
On
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
D E
Move
G
Select
Menu
Exit
Commercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
On
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
D E
Move
G
Select
Menu
Chapter 4
- Initial Volume : This setting configures the turn on volume of the TV.
- Min Volume : This setting assigns the minimum volume level that the user can access.
- Max Volume : This setting assigns the maximum volume level that the user can access.
-Volume Hold : If this function is on then user cannot adjust volume level
- Blank and Mute : If this function is on, sound will be muted when video is not present on the external
video source.
Volume
Back
20
0
100
Off
On
FF GG
FF GG
FF GG
FF GG
FF GG
D E
Move
F G
Adjust
Menu
Initial Volume
Min Volume
Max Volume
Volume Hold
Blank and Mute
Exit
Commercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
On
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
D E
Move
G
Select
Menu