Filter
Top Products
33
Chapter 4: Commercial Interface Menus
- Key Lock : This setting disables the keys on the front of the TV.
- IR(RCU) Type : This function assigns RCU type as TV1, TV2, TV3. This is used when more than 1 TV is being
installed in the same room.
Note : The remote must be configured to send the matching RCU Type corresponding to this setting.
This is done as follows : On the KM38R02 remote, press hold <SYSTEM> and <1> keys for 5 seconds to set it
to “TV1”. Press and hold <SYSTEM> and <2> keys for 5 seconds to set it to “TV2”. Press and hold <SYS-
TEM> and <3> keys for 5 seconds to set it to “TV3”.
Key Management
- This function will reset all data in the commercial interface menu to the factory defaults.
Reset Commercial Interface
Exit
Commercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
On
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
D E
Move
G
Select
Menu
Exit
Commercial Interface
Clone Management
Channel
OSD
Source
Volume
Pillow Speaker
Power Management
Key Management
Reset Commercial Interface
On
FF GG
GG
GG
GG
GG
GG
GG
GG
GG
GG
D E
Move
G
Select
Menu
Back
Do you want to reset all commercial
Interface data to the factory defaults?
Menu
Select
OK
Back
Off
TV1
FF GG
FF GG
D E
Move
F G
Adjust
Menu
Key Lock
IR(RCU) Type
Chapter 4