RCA P52730 CRT Television User Manual


 
The digital remote control that came
packed with your TV is also capable of
controlling a compatible audio
component.
To program the remote press and hold
the AUDIO button and then enter the
two-digit c.ode number for your brand
of audio equipment.
-Programming Remote to Control Audio Equipment
1. Refer to the chart below to find the
code number that corresponds to
the brand name of your audio
equipment. If more than one
number is listed, you may need to
try each one separately to find the
one that works.
2.Press and hold the AUDIO button
on remote (depending on which
button you want to program).
1 Press two number buttons (first
one, then the other) to enter the
code number for your brand of
audio equipment.
Note: You must press the two number
buttons while holding the AUDIO
button.
4. Point the remote at the audio
equipment and press the POWER
button to test the code number.
If the right number was entered,
the audio equipment will turn on.
If the audio equipment does not
react to the remote, repeat steps 1
thru 4 with another code number.
Operating Notes:
After the AUDIO button is programmed, the
buttons described below will operate the
basic functions of the audio equipment.
Depending on the age, brand, model, and
type of audio equipment, some models may
not be able to respond to all the function
buttons listed below. You will want to
experiment with each button to determine the
exact function for your component.
POWER: Press to turn on component.
Press again to turn off. Some components
will turn on automatically when you press
this button.
VOL: Press to change volume level.
CHAN: Press to select the next higher or
lower channel in the component's channel
memory.
Number Buttons: Press two numbers to
directly select a channel.
PLAY: Press to start component playing.
PAUSE: Press to pause play or record. To
release pause, press again.
STOP: Press to stop whatever the
component is doing: playing, recording,
rewinding, etc.
REW (Rewind): Press while component
is stopped to rewind tape.
FF (Fast Forward): Press while
component is stopped to fast forward tape.
REC (Record): Press to startrecording.
ANTENNA: Performs various functions
depending on the type of equipment.
Experiment with this button.
O4
Note: Refer to the information sheet packed with your remote control for the latest list of brand
names and code numbers. Because this list of brand names is continually growing, the
information sheet packed with your remote control may be a later version of this list and contain
additional brands and/or code numbers.
42