Filter
Top Products
146
Troubleshooting
This section contains tips to help you solve problems.
If this information does not help you solve the problem, please contact a customer service location listed at the end of this
manual.
Problems with the Power Supply
Item
Explanation Page
Power won’t turn
on
Is the BR-800’s power switch set correctly?
Make sure that the BR-800’s power switch is set to “USB” if you’re using USB bus power,
or to “ON” if you’re using the AC adaptor or batteries.
p. 18
Is sufficient power being supplied to your computer or USB hub?
The connection cannot be established if insufficient power is being supplied to the
BR-800. Make sure that none of the following cases apply.
• If you’re using a notebook computer that’s running on its battery, operation may
be unstable in the case of some computers. In this case, connect an AC adaptor to
your computer.
• The power management settings of your computer may be limiting the power that
is supplied to USB. Check the settings on your computer.
• In some cases, the BR-800 cannot be used with bus-powered hubs (USB hubs that
do not contain a power supply). Please use a self-powered hub (a hub that
contains a power supply).
–
Problems with the Sound
Item
Explanation Page
No sound
Is power to the BR-800 and any connected equipment turned on?
p. 34
Could the PHONES LEVEL be set to 0? p. 133
Are the audio cables connected correctly? p. 32
Could an audio cable be broken? –
Could the volume be turned down on the connected amp or mixer? –
Could the [MASTER] fader be lowered? –
Is an SD card inserted? p. 142
Could an SD card not supported by the BR-800 be inserted? p. 142
Could you be attempting to play back a phrase that is shorter than 1.0 seconds?
Phrases shorter than 1.0 seconds cannot be played back.
–
Can’t play back a
WAV file
Could you be attempting to play back a WAV file in an unsupported format?
p. 121
Insufficient volume
from a device
connected to the
GUITAR/BASS jack
or LINE IN jack
Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.
–
Is the volume of your external device adjusted correctly? –
No sound from a
specific track
Could the track’s volume level be lowered?
p. 38
Could the wrong V-track be selected? p. 39
Could the track be muted? p. 13
Can’t hear the
input source
Is INPUT SELECT set correctly? p. 37
Did you adjust the INPUT SENS knob? p. 37
Could the [REC LEVEL] knob be minimized? p. 38
Could DIR MONITOR be turned “OFF”? p. 125
BR800_e.book 146 ページ ２０１０年３月２日 火曜日 午後６時４０分