Filter
Top Products
18
Connecting
6 Select the output format.
6-1. Press the OUTPUT button until "300: Video Out Format" is shown in the display.
6-2. Use the VALUE/ENTER knob to select "1080/59.94i," "1080/50i," "720/59.94p," or "720/50p."
6-3. Press the VALUE/ENTER knob to confirm the selection. The video signal is output in the selected
video format.
If the aspect ratios of the video
selected in step 5. and the
output format selected in step
6. are different, select the
scaling type with "200: Scaling
Type" (p. 33) from the Menu
(p. 30).
Converting SD-SDI to HDV
By using the scaling feature of the VC-300HD/VC-200HD, SD-SDI component video can be
up-converted to HD size as well as converted to HDV. In this case, conversion can be
performed using the same procedure as shown on the previous page.
* If conversion cannot be performed properly, it is possible that the “140: SDI IN” (p. 32) from
the Menu (p. 30) is not set to “Auto.”
Converting HD-SDI to DV
By using the scaling feature of the VC-300HD/VC-200HD, HD-SDI can be down-converted to
SD size as well as converted to DV. In this case, after connecting using the procedure on the
previous page, select “SD” in Step 6.
* When converting to PAL, select "576/50i" in step 6. For NTSC, select “480/59.94i.”
Converting SD-SDI to DV
Perform the settings on the previous page, and connect the SD video device to the HD-SDI
IN connector. In this case, select “480/59.94i” in Step 6.
* When converting to PAL, select "576/50i" in step 6. For NTSC, select “480/59.94i.”
Converting HD-SDI (SD-SDI) to Component
Perform the settings on the previous page, and connect the HD video device to the
COMPONENT OUTPUT connector. The selection made in Step 6 determines the format of
the video that is output. Set this item according to the connected device.
* When changing the output video frame rate, please select an appropriate value in step 6.
* Refer to the user’s manual that came with your HD video equipment to find out which video
formats it supports.
* When “480/59.94i” is used in Step 6, SD component is output. When converting to PAL,
select "576/50i" in step 6. For NTSC, select “480/59.94i.”
Converting HD-SDI (SD-SDI) to DVI-I
Perform the settings on the previous page, and connect a DVI-I compatible device, such as a
LCD monitor, to the DVI-I OUTPUT connector. The selection made in Step 6 determines the
format of the video that is output. Set this item according to the connected device.
* When changing the output video frame rate, please select an appropriate value in step 6.
Changing HD-SDI (SD-SDI) Size
The VC-300HD/VC-200HD converts (cross converts) 1080i size HD-SDI to 720p, and SD-SDI
and HD-SDI can be mutually converted. In this case, select the format to be converted in Step
6, and connect the video device supporting the output format to the HD-SDI OUT connector.