Runco CW-42HD Flat Panel Television User Manual


 
Controls and Functions
Runco CinemaWall Owner’s Operating Manual 7
PRE
L
IMINAR
Y
Figure 2-3. CW-50XA and CW-61 Connector Panel
1. POWER INPUT (100 to 240 VAC)
Connect the CinemaWall to power here, using the included power cord.
2. EXTERNAL SPEAKER OUTPUTS
Connect optional, external speakers here. Maintain the correct polarity. Connect the
(positive) and (negative) speaker wires to the EXT SPEAKER terminals on both
the LEFT and RIGHT channels. Please refer to the owner’s manual for your speakers.
3. VIDEO1, 2 (RCA, S-Video)
Standard, Composite video and S-Video inputs for connecting a DVD player, satellite
receiver, camcorder, laser disc player or Super VHS (S-VHS) VCR.
4. AUDIO1, AUDIO2, AUDIO3
Stereo, RCA-type audio inputs. You can associate each audio input with any video
input -- that is, specify which audio input becomes active when a given video source
is selected. For more information, refer to
Audio on page 34.
5. DVD/HD1
DVD/HD2
Standard-definition (480i/576i) or high-definition (720p/1080i), YPrPb component
inputs for connecting a DVD player or high-definition TV source.
6. PC/RGB (15-pin D-Sub)
Connect an analog RGB signal from a computer or DTV decoder here.
For best results, do not run your DVD player in progressive mode.
AC IN
RIGHT
+ -
LEFT
- +
5
6
7
8
10
9
4
3
2
1
Tip