Filter
Top Products
Installation
16 VX-3000d Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the VX-3000d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 17
2
Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
28
3
Mount the projector 38
4
Connect the DHD Controller to the projector 40
5
Connect signal sources to the DHD Controller 41
6
Connect external controller to RS-232 port (optional) 46
7
Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional)
47
8
Connect projector, DHD Controller and lens motor (if
present) to AC power and power up
49
9
Primary lens adjustments: projected image size (zoom),
position (shift) and focus
20, 50
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
51
11
Install CineWide anamorphic lens (optional) 51
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus
51
13
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
63