Filter
Top Products
Installation
VX-3000d Series Installation/Operation Manual 49
PRE
L
IMINAR
Y
Connecting to AC PowerProjector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the VX-3000d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
3.8
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
4. Turn on the main power switch at the rear of the projector. The POWER LED lights
orange. The LAMP and TEMP LEDs light red briefly, then go out.
5. Press the ON button on the remote control (or the ON/STANDBY ( ) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting VX-3000d.” On the projector, the POWER LED flashes green to indicate that
it is warming up.
6. When the projector is ready for use, the POWER LED lights solid green. On the DHD
Controller, the fluorescent display indicates the active source, input resolution/frame
rate and aspect ratio; for example:
VX-3000d HDMI 1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate