Filter
Top Products
Operation
68 VX-3000d Series Installation/Operation Manual
PRE
L
IMINAR
Y
Color Saturation: On your external test pattern source, select a color bar pattern like the
one shown in
Figure 4-4.
Figure 4-4. Typical Color Bar Pattern for Adjusting Color Saturation and Tint
1. Press the MENU button on the remote control or DHD Controller front panel.
2. Select Service from the Main Menu and press ENTER.
3. Enter the Service menu passcode.
4. Select Display Device from the Service menu and press ENTER.
5. Press ENTER again to select Configure.
6. Select Diagnostic and press ENTER.
7. Select Blue from the Diagnostic menu, then press ENTER to display only the blue color
channel.
8. Press RETURN (or MENU) repeatedly to return to the Main Menu.
9. Select Picture from the Main Menu and press ENTER.
10.Select Color from the Picture menu and press ENTER.
gray
yellow
cyan
green
magenta
red
blue