Filter
Top Products
Installation
28 VX-3000d Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.5
Installing the Optional
CineWide/AutoScope
Lens Mount
If you are installing a standard (non-CineWide) VX-3000d, skip this step and proceed with
Mounting the VX-3000d (page 38).
If you are installing a CineWide projector equipped with a prismatic
(Whitney) anamorphic lens, proceed with
Installing the Fixed CineWide
Base Plate (Prismatic Lens) (page 33).
If you are installing a CineWide projector equipped with a
cylindrical (Rainier
II or McKinley) anamorphic lens, proceed
with
Installing the Fixed CineWide Base Plate (Cylindrical
Lens) (page 35).
If you are installing a VX-3000d/CineWide with AutoScope or VX-3000d Ultra/CineWide
with AutoScope, proceed as follows to install the AutoScope lens motor.
1. Do not install the CineWide lens yet, only the fixed CineWide
base plate or AutoScope lens motor. You will install the CineWide
lens after you install the projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
F
O
C
U
S
Note