Filter
Top Products
ENG-6 ENG-7
Basic Connections/Auto Setup
You will need to connect the DVD-VCR to a TV and run
Auto Setup. The Auto Setup will automatically search for
channels and then set your DVD-VCR's internal clock.
NOTES:
• See Appendix A for Advanced Connections.
• Standard RF or Line connection between your TV
and DVD-VCR are required to run DVD+VCR
setup menu, even if you connect S-Video or
Component Video Output for a better picture
quality.
1
Connect the RF Antenna Cable to your DVD-VCR
Connect an external indoor/outdoor antenna or wall
outlet antenna cable to the Ant-In jack on the rear
panel. (RF Through Only)
2 Connect your DVD-VCR to a TV
RF Connection
Using the RF antenna cable, connect the OUT jack
(TO TV) on the rear panel of your DVD-VCR to
your TV’s Antenna Input.
Line Connection
Using an RCA-type audio/video cable (red, white,
yellow), connect the LINE OUT jacks on the rear
panel of your DVD-VCR to your TV's Line In jacks.
Use the three cables as follows: red for right audio,
white for left audio, and yellow for video.
NOTE: If your TV is equipped with RCA jacks, it is
better to use the Line Connection method.
3 Plug In
Your DVD-VCR's power should be plugged into a
standard 120V/60Hz wall outlet. Avoid pressing any
buttons on the remote control or on the unit during
an Auto Setup. While your DVD-VCR is running an
Auto Setup, “AUTO” will blink. When Auto Setup is
complete, the current time will be displayed on the
front panel displayed. In case Auto Clock set fails to
locate a channel to set the clock, you should set
the clock manually. See page 12.
From Antenna or Cable
1
To TV’s Antenna Input
2
3
Insert Batteries into Remote
Front Panel Display
• Remove the battery cover on the remote
• Insert two 1.5V “AAA” batteries as shown,
making sure of the correct polarities(+/-)
• Slide the cover back onto remote.
4 5
1 2 3
1 When the light is on, DVD is operating.
2 The time, counter position, time remaining or
current deck status is indicated.
3 VCR is activated.
4 DVD or VCD, CD media is loaded.
5 VHS videotape is loaded.
Front Panel Overview
Rear Panel
1 2 3 4
5 6 7 8 9 10 11 12 13 14 15 16 17 18
1 DVD DECK
2 DVD OPEN/CLOSE
3 VCR DECK
4 VCR EJECT
5 POWER
6 EZ VIEW
7 REWIND/REV
8 STOP
9 PLAY/PAUSE
10 FAST-FORWARD/FWD
11 RECORD
12 FRONT PANEL DISPLAY
13 CHANNEL /
14 DVD-VCR SELECT
15 PROGRESSIVE
16 LINE IN 2 COMPOSITE VIDEO JACK
17 LINE IN 2 LEFT AUDIO JACK
18 LINE IN 2 RIGHT AUDIO JACK
1 2 3 4 5 6 7 8
1 S-VIDEO OUT
2 DIGITAL AUDIO OUT(COAXIAL)
3 COMPONENT VIDEO OUT
4 AUDIO LINE OUT TO TV
(S-VIDEO OR COMPONENT)
5 LINE IN 1
6 LINE OUT TO TV (COMPOSITE)
7 RF ANTENNA INPUT
8 RF OUT TO TV (RF THROUGH ONLY)
00368A DVD-V4600/XAC-ENG 12/5/03 10:24 AM Page 6